When you're ready, DB Ready!

Cooling SOP

I. The inspector shall inspect:

  1. the cooling system using normal operating controls.

II. The inspector shall describe:

  1. the location of the thermostat for the cooling system; and
  2. the cooling method.

III. The inspector shall report as in need of correction:

  1. any cooling system that did not operate; and
  2. if the cooling system was deemed inaccessible.

IV. The inspector is not required to:

    1. determine the uniformity, temperature, flow, balance, distribution, size, capacity, BTU, or supply adequacy of the cooling system.
    2. inspect portable window units, through-wall units, or electronic air filters. 
    3. operate equipment or systems if the exterior temperature is below 65° Fahrenheit, or when other circumstances are not conducive to safe operation or may damage the equipment. 
    4. inspect or determine thermostat calibration, cooling anticipation, or automatic setbacks or clocks. 
    5. examine electrical current, coolant fluids or gases, or coolant leakage.